Roller Shutter Door Repairs in Zimbabwe

Typical response: Diagnosed from photos before we travel

A roller shutter door that has stopped working is holding up whatever the building does. We repair doors in Zimbabwe on booked visits, with our own team travelling up from South Africa, so the work is planned rather than same-day. What we can promise is a visit that fixes everything found, and a site left able to handle the next small fault without waiting for us.

Roller shutter door repairs we handle in Zimbabwe

• Curtain damage from forklift and vehicle strikes, repaired slat by slat.
• Barrel and spring faults where the door has gone heavy or will not hold position.
• Guide damage straightened or renewed so the curtain tracks properly again.
• Motor and gearbox failures repaired or replaced, with the manual override tested afterwards.
• Control and safety-edge faults traced properly rather than bypassed.
• Bottom rail and locking repaired where a door has been forced.

Diagnosis before the trip

We ask for photographs of the fault, the barrel end, the guide section, the bottom rail and any plate on the motor, plus the opening size. Getting the diagnosis right before a vehicle leaves South Africa is the whole job, because the alternative is arriving with the wrong part and a border between you and the right one.

We fix the whole door, not the presenting fault

On a booked trip it makes no sense to replace one failed component and leave three that are close behind it. We assess the complete assembly, quote everything that should be done while we are there, and let you decide. It is more on the invoice and considerably less than a second visit.

Doing the whole site in one visit

Where a factory, mine or estate has several doors, we survey and repair all of them on the same trip. That is the most economical way to buy our time, and it puts every door on the site onto the same condition record.

Repairs that keep old doors running

A great many Zimbabwean industrial doors have been in service for decades and the original profiles are long out of production. We fabricate slats, adapt guides and machine barrel components rather than telling you a door is finished, because replacing it means a new door crossing a border.

Making a door workable during outages

Half the roller shutter faults we are called to on this side started as a door being forced by hand during a power cut because the manual release had seized or nobody had been shown it. Freeing and testing the release, and showing the people who use the door how it works, is part of every repair we do here.

Surge protection on control gear

Unstable supply destroys more control boards in Zimbabwe than mechanical wear destroys motors. Where we repair or replace a drive we fit proper surge protection at the same time, because a new board on an unprotected supply has a short life.

Leaving the site able to help itself

We put together a spares kit for the doors on your site and show your artisans or electrician how to deal with the routine items. We would rather you called us for the things that genuinely need us.

Booking a repair in Zimbabwe

Send photographs, the opening sizes and the location, and tell us how many doors are involved. We will tell you what we would bring and when we are next travelling to that part of the country.