Roller shutter & garage doors across Zimbabwe. Same-day callout, our own teams countrywide.

Strong, and repairable on site

Steel Garage Doors in Zimbabwe

Galvanised steel garage doors in 0.5mm to 0.8mm sheet, Chromadek or powder-coated, built to your measured opening as roll-up, sectional or tip-up. Repairs on any make.

Flush dark sectional garage door on a contemporary house
  • 0.5mm to 0.8mm galvanised sheet
  • Chromadek or powder-coated to any RAL
  • Roll-up, sectional or tip-up

Steel is what we build most Zimbabwean orders from. It is the strongest material for the money, it takes hard use, and above all it can be repaired on site with ordinary workshop skills. On a cross-border supply that last point outweighs almost everything else.

Steel garage doors we supply into Zimbabwe

  • Steel sectional doors in ribbed, panelled and flush profiles.
  • Steel roll-up doors for low-headroom and out-of-square openings, and for outbuildings.
  • Steel tip-up doors on new or existing frames.
  • Insulated steel doors where the space is worked in all day.

Repairable with what is available

A dented steel panel can be straightened, a damaged section replaced, a frame welded. Any competent workshop in a Zimbabwean town can work on a steel door, which means a knock does not become an import. That is why we specify steel on nearly every working building we supply here.

Galvanised before it is coated

Every steel door we supply is galvanised before it is coated, so a scratch stays a scratch rather than becoming a rust line down the panel. In the valley and the lowveld we specify heavier galvanising with a topcoat over it, because heat and humidity there are considerably harder on steel than on the highveld.

Gauge specified generously

Because service intervals here are longer and replacement is a shipment, we specify gauge on the durable side rather than the economical side. A slightly heavier panel costs a little more once and removes a category of problem entirely.

Steel doors on farms, mines and workshops

On any building where machinery, vehicles or hard use are involved, steel is the only sensible answer. A damaged slat or section is swapped or fabricated; the door does not become a write-off.

Insulated steel doors

An insulated steel door is stiffer, quieter and far better where the space is a workshop, an office or a flatlet. Under lowveld or valley sun the temperature difference in a working building is substantial.

Security on a steel garage door

Panel strength is only part of it. The locking, the track fixings and, on a motorised door, a drive that holds the door down are what stop a door being lifted. On Zimbabwean orders we specify locking heavier than the equivalent domestic job.

Spares supplied with the door

Every steel door goes out with a spares kit sized to it: the wearing hardware, seals and, on motorised doors, electrical spares and a remote. It is the cheapest insurance available on a door that lives across a border from its manufacturer.

What a steel garage door costs

The most cost-effective door for most openings here. Priced on width and height, panel profile, gauge, coating, insulation and drive, with crating, transport, clearing and installation shown separately.

Common questions

About steel garage doors

Between 0.5mm and 0.8mm galvanised sheet. The gauge is the specification that matters most — thin sheet dents when something falls against it. We quote the gauge on every proposal so you can compare offers on the same basis.

Chromadek is a factory-applied coil coating: tough, consistent and hard to beat for durability. Powder coating lets us match any RAL colour to the trim on your house. Both go over galvanising, never over bare steel.

Only if the coating is breached and left. It starts at the bottom rail, where the door stands in driveway water, and around fixings. We use galvanised bottom rails, seal cut edges and fit a proper bottom seal. Inland a maintained steel door runs well over a decade.

We do not work that way. Older South African garages are rarely square, and forcing a stock-size door into an out-of-square opening is what leaves the daylight gap down one side. Every door is built to the measured opening.

Related

Also worth a look

Industrial Roller Shutter Doors

Built heavy, maintained on site

Heavy-duty galvanised shutters for warehousing and industrial yards in Harare and Bulawayo, built for wide vehicle access and hard use.

  • Openings to 8 000mm wide
  • 0.8mm–1.2mm galvanised slat
  • Chain hoist or motorised

Roll-Up Garage Doors

Simple, repairable, hand operable

Roll-up garage doors curl into a drum above the opening instead of running back along the ceiling, so the garage keeps its full roof space and…

  • Insulated aluminium or galvanised slat
  • Openings to 5 000mm wide
  • Remote and battery backup available

Wooden Garage Doors

Right on the right building

Meranti, cedar and saligna garage doors built on a galvanised steel frame and sealed on all six faces before they are hung. Tip-up or sectional, manual…

  • Timber on a galvanised steel frame
  • Sealed all six faces before hanging
  • Tip-up or sectional mechanism

Next step

Get a roller shutter door quote in Zimbabwe

Tell us the opening size and what the door has to do. We will give you a firm price for Zimbabwe and a date we can be on site.

Request a callback

Two working hours is our usual turnaround on callbacks.

In a hurry? 076 315 4219

Call now 0861 000 431 Emergency 24 hours Get a quote Free